Skip to content
Sales in Over 77 Countries
Trusted by the World's Best
Visit Us at these Trade Shows
First Contact Polymer
*NEW! FC WR Water Resistant Formula
*NEW! All-Inclusive 1Liter & 500ml Kits
All-Inclusive Kits-One Click
FC Gold Formula - For Gold Coated Optics
Copper, Brass & Cu/Al Alloys Polymer
Plastics Formula Polymer
Black Polymer - For Backside Reflection Hiding
Kits w/FLAT RATE SHIPPING - U.S. Only
Red Polymer Kits and All Other Polymer Kits
Spray First Contact
Bulk Bottles - 500ml and 1 Liter
Accessories, Spray Heads, Kits, and Bottles
WHO Hand Sanitizer
Instructions & Videos
High Powered Laser Optics
Telescopes: Refractors, SCT, Dobs, etc.
Testimonials, News & Featured Guest
Featured Astrophotography Guest
SDS & Tech Data
Distributors / Resellers/ Translations
Website in other Languages
Europe & UK
Have a Question?
Sales in Over 77 Countries
Trusted by the World's Best:
Orings - Custom Size 5 To 10 Inch (127.0 to 254.0mm) OD (Sold Individually)
Enter size in 1/16th inch or 1 millimeter increments
Custom Size In 1/16th" or 1 mm Increments
Enter Custom Size
Enter Your Equipment Details Below
Equipment Info: (Mfgr, Model, etc.)
We will manufacture a custom oring to fit your specific optic. Measure the diameter of your optic just inside the retaining ring (or housing if retained from the back side) and provide the measurement to the next smallest 1/16th inch or 1 millimeter measurement.
This measurement establishes the ID of your retaining ring (or housing, etc.) to determine the OD of the oring you require.
: An optic is 8 and 5/8th inch (219.1mm) diameter measured just inside the retaining ring. Enter 8 and 1/2th (or 215.9mm) diameter in the text box. Please provide the name and model number of the equipment so we can retain this information for your next order.
These are chemical resistant orings that do not swell when in contact with the polymer. Do not use cheap Butyl or Buna orings, they will absorb solvents, swell and can break down leaving residue. Read our
online Oring document
with photos and text to explain oring use.
1. If the orings are not flat when received and do not lay flat on your optic you can lay on a flat surface and apply mild heat with a heat gun and the orings will flatten. Allow to cool then apply to your optic! 2. The oring may trap a very thin layer of polymer underneath and leave polymer residue when peeled. This possible situation can be avoided by coating one side of the oring with two (2) coats of polymer (or dipping), and once dry you can set in place and use per directions.
ordering orings we can ship via USPS for less than than FedEx. Let us know if you prefer USPS and we will adjust the shipping cost to a flat rate $6.00 before charging your card. We will also send you a revised invoice showing the adjusted total cost. Applies to the Lower 48 United States only.