Skip to content
Sales in Over 77 Countries
Trusted by the World's Best
Visit Us at these Trade Shows
First Contact Polymer
*NEW! FC WR Water Resistant Formula
*NEW! All-Inclusive 1Liter & 500ml Kits
All-Inclusive Kits-One Click
FC Gold Formula - For Gold Coated Optics
Copper, Brass & Cu/Al Alloys Polymer
Plastics Formula Polymer
Black Polymer - For Backside Reflection Hiding
Colorless Formula Polymer
Red Formula Polymer
Spray First Contact
Bulk Bottles - 500ml and 1 Liter
ESD Formula & Other Specialty Items
Accessories, Spray Heads, Kits, and Bottles
WHO Hand Sanitizer
Instructions & Videos
Our YouTube Channel
Telescope Product Finder Instructions
Gran Telescopio Canarias
High Powered Laser Optics
Telescopes: Refractors, SCT, Dobs, etc.
Testimonials, News & Featured Guest
Featured Astrophotography Guest
SDS & Tech Data
Distributors / Resellers/ Translations
Website in other Languages
Europe & UK
Have a Question?
Sales in Over 77 Countries
Trusted by the World's Best:
Orings - 2" to 2.875" (50.8 to 73.0mm) OD (Bag of 5) (Click to Select Size)
Select size BEFORE adding item to cart
2" Oring Size:
2" or 50.8mm
2.125" (2 1/8") or 53.98mm
2.250" (2 1/4") or 57.15mm
2.375" (2 3/8") or 60.3mm
2.5" (2 1/2") or 63.5mm
2.625" (2 5/8") or 66.68mm
2.750" (2 3/4") or 69.85mm
2.875" (2 7/8") or 73.0mm
Orings are used to stop First Contact Polymer flow on or under optic retaining rings (or retaining flanges if retained from backside).
Retaining rings sometimes do not fit sufficiently tight to the optic to disallow polymer from wicking under the ring. Once under a retaining ring the polymer will not pull out and will tear, leaving residue under the ring. Additionally, some retaining rings are plastic and are incompatible with the solvents in First Contact polymer so contact must be avoided.
These are chemical resistant orings that do not swell when in contact with the polymer. Do not use cheap Butyl or Buna orings, they will absorb solvents, swell and can break down leaving residue. Read our
online Oring document
with photos and text to explain oring use.
1. If the orings are not flat when received and do not lay flat on your optic you can lay on a flat surface and apply mild heat with a heat gun and the orings will flatten. Allow to cool then apply to your optic! 2. The oring may trap a very thin layer of polymer underneath and leave polymer residue when peeled. This possible situation can be avoided by coating one side of the oring with polymer (or dipping), and once dry you can set in place and use per directions.
ordering orings we can ship via USPS for less than than FedEx. Let us know if you prefer USPS and we will adjust the shipping cost to a flat rate $6.00 before charging your card. We will also send you a revised invoice showing the adjusted total cost. Applies to the Lower 48 United States only.